Engineering Sciences
Apparent thermal contraction of cement pastes up to 175 °C: Experimental characterization, multiscale model, repercussions at the concrete scale
Publié le - Cement and Concrete Research
Thermal deformation of cement-based materials is critical for infrastructure exposed to elevated temperatures. This study combines experimental characterization and multiscale modeling to investigate the apparent thermal contraction observed in cementitious systems. The coefficient of thermal expansion (CTE) and elastic modulus were measured up to 175 °C on C-S-H paste, cement paste, mortar, and concrete. Elevated temperature induced a 27–41% reduction in elastic modulus across all investigated scales. For cement pastes, thermal deformation began to decrease at approximately 70–80 °C and became contraction-dominated above 135–160 °C. Contraction is attenuated at mortar scale and nearly disappears at the concrete scale due to aggregate dilution effect. Experiments on C-S-H paste revealed that this behavior is primarily governed by C-S-H and provides, for the first time, direct measurements of the CTE of C-S-H over this temperature range. A multistage thermal cycle was developed to decouple thermal expansion from dehydration effects, demonstrating that the measured contraction originates from dehydration shrinkage. Consequently, the observed contraction does not reflect a negative intrinsic thermal expansion but rather an apparent thermal contraction. Molecular simulations of C-S-H support the role of water loss in both apparent contraction and stiffness degradation. Micromechanical modeling, using phase assemblages from thermodynamic modeling as input, reproduces the main trends in thermoelastic properties and provides a physically grounded interpretation of the roles of C-S-H, porosity, phase evolution, and aggregate dilution in the response of cement-based materials above 100 °C.